How to improve the thermal oil fired vertical boiler efficiency oil boiler thermal efficiency is a lot of users are taken into account, we believe that this issue is the direction of each used in the production of various types of oil boiler manufacturers have been in the study. Many users at the time of the oil furnace to operate, often in the actual production process, we found some new problems, but all the problems, the headache is higher oil boiler flue gas temperature, low thermal efficiency the phenomenon that a serious impact on our work, then how should we do to improve the thermal efficiency of it? need to understand this is to meet the low-temperature characteristics of the thermal oil comes as synthetic heat transfer oil. However, the vast majority of synthetic HTF complex biphenyls, benzene derivatives of both components, or a vapor of volatiles has strong carcinogenicity, it is strongly recommended to select customers conducting oil mineral oil products. Second, conducting oil products to meet the low temperature performance process, but also have a relatively high flash point required. In general, oil engineers suggest, low flash point not lower than the HTF opening 200 ℃. After a professional manufacturer of continuous research and improvement of its equipment, in order to improve its thermal efficiency was found to be increased oil boiler heating surface of the tail, say, air preheater and economizer. But when organic heat carrier furnace return temperature is high, you can not set the economizer, air preheater can only be set to alleviate the situation. So if the oil boiler and not other low-temperature heating system heat exchanger, then the only way to improve energy efficiency is adding air preheater. After adding air preheater can be a corresponding increase in the flow rate of heat-conducting oil, oil boiler in order to ensure safe, reliable and stable work, the thermal efficiency of the boiler plant with thermal oil will be a corresponding increase.

What is the difference fired fired vertical boilers and gas boilers in, why should phase out coal-fired boilers? From the nominal point of view, fuel gas boilers and coal-fired boilers obvious difference is the use of different, the former use of natural gas, which uses coal.

Fangkuai Boiler has more than 200 after-sales service outlets across the country. Each after-sales service outlet is equipped with a professional fired vertical boiler technical engineer, providing 24-hour emergency repair services, and has sufficient spare parts and wearing parts all year round, convenient. Customers change in time.

Industrial gas steam fired vertical boiler for industrial use industrial gas steam boiler is a low-pressure gas steam boiler, but its high thermal conductivity temperature of the liquid inside, and the liquid explosive is mostly, if working in industrial gas steam boiler thrown thermally conductive fluid leak and cause a fire or even a large possibility of an explosion, which is very dangerous, so run industrial gas steam boiler safety is often worth the length of the face. Because the range of high temperatures (above 320 ℃), low voltage (0.3 to 0.5MPa), the heating temperature can be precisely controlled, it can replace the original steam boiler heating. Industrial gas steam boiler is heated up to a temperature of 350 ℃, molten salt furnace is heated up to a temperature of 530 ℃. Because the ash can not be produced by industrial combustion gas steam boiler fuel gas, if the gas and air mixture into the furnace is injected within a certain range may explode. Gas steam boiler operating temperatures above 400 ℃ oil and molten salt heat transfer medium, having a molten salt heat steam than the gas lifetime advantages, but otherwise are at a significant disadvantage, in particular the complexity of running the system.